PM0214 datasheet(174/245 Pages) STMICROELECTRONICS

174 / 245 page

The STM32 Cortex-M4 instruction set

PM0214

174/245

DocID022708 Rev 4

MRS

R0, PRIMASK ; Read PRIMASK value and write it to R0

3.11.7

MSR

Move the contents of a general-purpose register into the specified special register.

Syntax

MSR{cond} spec_reg, Rn

where:

•

‘cond’ is an optional condition code, see Conditional execution on page 64.

•

‘Rn’ is the source register.

•

‘spec_reg’ can be any of: APSR, IPSR, EPSR, IEPSR, IAPSR, EAPSR, PSR, MSP,

PSP, PRIMASK, BASEPRI, BASEPRI_MAX, FAULTMASK, or CONTROL.

Operation

The register access operation in MSR depends on the privilege level. Unprivileged software

can only access the APSR, see Table 5: APSR bit definitions on page 20. Privileged

software can access all special registers.

In unprivileged software writes to unallocated or execution state bits in the PSR are ignored.

When you write to BASEPRI_MAX, the instruction writes to BASEPRI only if either:

•

Rn is non-zero and the current BASEPRI value is 0

•

Rn is non-zero and less than the current BASEPRI value.

See MRS on page 173.

Restrictions

Rn must not be SP and must not be PC.

Condition flags

This instruction updates the flags explicitly based on the value in Rn.

Examples

MSR

CONTROL, R1 ; Read R1 value and write it to the CONTROL register

PM0214 Datasheet(PDF) 174 Page - STMicroelectronics